Difficulty
Moderate
Steps
7
Time Required
30 minutes
Sections
2
- Barrel
- 3 steps
- Cord and Plug
- 4 steps
Flags
0
BackRevlon One-Step Hair Dryer
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Barrel
- First, remove the pink panels on each side of the handle in order to access the screws.
- Use the iFixit opening tool to remove the pink panels.
First, remove the pink panels on each side of the handle in order to access the screws.
Use the iFixit opening tool to remove the pink panels.
1024
Step 2
- After removing the pink panels, there will be one visible screw on each side of the dryer handle measuring at 11mm.
- Carefully unscrew both of these screws with a tri-point Y000 screwdriver.
- Next, completely remove the screws out of the dryer handle.
After removing the pink panels, there will be one visible screw on each side of the dryer handle measuring at 11mm.
Carefully unscrew both of these screws with a tri-point Y000 screwdriver.
Next, completely remove the screws out of the dryer handle.
Step 3
- Remove the barrel by twisting and pulling it away from the handle of the dryer.
- Before attempting to take the barrel off, make sure the dryer powered completely off and is cool to the touch.
Remove the barrel by twisting and pulling it away from the handle of the dryer.
Before attempting to take the barrel off, make sure the dryer powered completely off and is cool to the touch.
Step 4
Cord and Plug
- Next, slide down the air inlet and the setting dial to reveal the 11mm screws on each side of the handle at the bottom of the hair dryer.
Next, slide down the air inlet and the setting dial to reveal the 11mm screws on each side of the handle at the bottom of the hair dryer.
Step 5
- There will be one visible screw on each side of the dryer at the bottom of the handle, measuring at 11mm.
- Carefully unscrew both of these screws with a tri-point Y000 screwdriver.
- Store screws in a safe place, you will need them to reassemble the device later.
There will be one visible screw on each side of the dryer at the bottom of the handle, measuring at 11mm.
Store screws in a safe place, you will need them to reassemble the device later.
Step 6
- Place the iFixit opening tool along the seams of the handle and pry the two pieces apart.
Place the iFixit opening tool along the seams of the handle and pry the two pieces apart.
Step 7
- Once you have exposed the inside of the dryer, you will see a clear port at the very end where the cord is connected and plugged into.
- Now, with your thumb and pointer finger gently pinch the top and bottom of the clear port.
- Next with your free hand carefully pull the cord out of the port of the dryer handle.
Once you have exposed the inside of the dryer, you will see a clear port at the very end where the cord is connected and plugged into.
Now, with your thumb and pointer finger gently pinch the top and bottom of the clear port.
Next with your free hand carefully pull the cord out of the port of the dryer handle.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Kateria Dykes
Member since: 03/21/2022
231 Reputation
1 Guide authored
Badges:
7
+4 more badges
Team
University of Alabama, Team 1-4, Bedsole Spring 2022
Member of University of Alabama, Team 1-4, Bedsole Spring 2022
UA-BEDSOLE-S22S1G4
3 Members
5 Guides authored
