Revlon Rvdr5061 Heating Element Assembly Replacement Repair Guide

Difficulty

Difficult

Steps

7

Time Required

                          5 - 15 minutes            

Sections

2

• Fan/Motor Assembly
• 4 steps
• Heating Element Assembly
• 3 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackRevlon RVDR5061

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Fan/Motor Assembly               

• Using a Phillips #3 screwdriver, remove the single 25 mm Phillips head screw in the handle by turning it counterclockwise.

Using a Phillips #3 screwdriver, remove the single 25 mm Phillips head screw in the handle by turning it counterclockwise.

1024

Step 2

• Using a medium flathead screwdriver or better yet iFixit plastic opening tools, gently pry apart the handle from the power cord.

Using a medium flathead screwdriver or better yet iFixit plastic opening tools, gently pry apart the handle from the power cord.

Step 3

• After pulling apart the housing, all internals will be free to remove.

After pulling apart the housing, all internals will be free to remove.

Step 4

• The fan/motor assembly is connected to the heating element assembly at two points need to be desoldered. After pulling the attached wires through the holes the fan/motor assembly will be free from the heating element assembly. Congratulations you have now completely removed the fan/motor assembly from this hair dryer!

The fan/motor assembly is connected to the heating element assembly at two points need to be desoldered. After pulling the attached wires through the holes the fan/motor assembly will be free from the heating element assembly. Congratulations you have now completely removed the fan/motor assembly from this hair dryer!

Step 5

              Heating Element Assembly               

• Once the fan/motor assembly is disconnected from the heating element assembly you will see that the heating element assembly is connected to a circuit board by four wires. The color of these wires are grey, black, purple and brown.

Once the fan/motor assembly is disconnected from the heating element assembly you will see that the heating element assembly is connected to a circuit board by four wires. The color of these wires are grey, black, purple and brown.

Step 6

• Desolder these four wires one by one from the circuit board.

Desolder these four wires one by one from the circuit board.

Step 7

• The heating element assembly will now be separated from the circuit board and can be replaced with a new one.

The heating element assembly will now be separated from the circuit board and can be replaced with a new one.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Soneil Pitamber                     

Member since: 07/11/2018

97 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S2-G2, Wilson Summer 2018                        

                                                  Member of IUPUI, Team S2-G2, Wilson Summer 2018 



                    IUPUI-WILSON-SU18S2G2                     


                                            4 Members                     


                                            2 Guides authored