Difficulty

Easy

Steps

8

Time Required

                          5 - 10 minutes

Sections

1

  • Belt
  • 8 steps

Flags

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackRicatech-RTT22 Turntable

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

http://www.ricatechstore.com/garantie-en… (new parts available)

For original spare parts, please contact:

+31(0)10-4626733

support@ricatech.com

What you need

Step 1

              Belt
  • Remove the arm holder by moving the needle to the side and lifting up.
  • Remove the rubber pad by lifting it up.

Remove the arm holder by moving the needle to the side and lifting up.

Remove the rubber pad by lifting it up.

1024

Step 2

  • Flip over the record player. There should be screws (10mm phillips head) on the back.
  • Use your phillips head screwdriver to remove each screw (keep them in a safe place for later).

Flip over the record player. There should be screws (10mm phillips head) on the back.

Use your phillips head screwdriver to remove each screw (keep them in a safe place for later).

Step 3

  • There will be three wires connecting the top to the bottom. Disconnect them carefully.
  • Put the back component of the record player to the side.

There will be three wires connecting the top to the bottom. Disconnect them carefully.

Put the back component of the record player to the side.

Step 4

  • Use your phillips head screwdriver to remove the three screws (8mm phillips head) holding the motor in place.
  • Keep in mind that there is some pressure on the motor, since the belt holds together the motor and turntable.

Use your phillips head screwdriver to remove the three screws (8mm phillips head) holding the motor in place.

Keep in mind that there is some pressure on the motor, since the belt holds together the motor and turntable.

Step 5

  • Unbolt (6mm bolt) the turntable from the housing using your wrench.
  • Since the turntable is designed to rotate, make sure the other side of the pin is kept from rotating while unbolting.

Unbolt (6mm bolt) the turntable from the housing using your wrench.

Since the turntable is designed to rotate, make sure the other side of the pin is kept from rotating while unbolting.

Step 6

  • Carefully removed the rubber band from around the motor and extract the turntable from the device.

Carefully removed the rubber band from around the motor and extract the turntable from the device.

Step 7

  • Remove the damaged belt. Place the new belt around the turntable.

Remove the damaged belt. Place the new belt around the turntable.

Step 8

  • Follow the instructions backwards to reassemble the record player.

Follow the instructions backwards to reassemble the record player.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Celeste Greenbaum

Member since: 03/08/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       Delft University of Technology, Team S1-G14, Flipsen Spring 2017                        

                                                  Member of Delft University of Technology, Team S1-G14, Flipsen Spring 2017 



                    TUD-FLIPSEN-S17S1G14                     


                                            3 Members                     


                                            1 Guide authored