Ricoh Shotmaster 130Z Shutter Led Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

Suggest a time??

Sections

Shutter LED
4 steps

Flags

BackRicoh Shotmaster 130Z
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Shutter LED

Using a Phillips J00 head remove the three 5mm screws on both left and right side of the camera as well as the one in back of it.

Using a Phillips J00 head remove the three 5mm screws on both left and right side of the camera as well as the one in back of it.

1024

Step 2

Using the same J00 phillips head screwdriver proceed to removing the remaining four 5mm screws on the bottom of the camera.
Last, using the same #00 phillips head screwdriver remove the two 0.6mm screws which are one on each side of the tripod connection dip.

Using the same J00 phillips head screwdriver proceed to removing the remaining four 5mm screws on the bottom of the camera.

Last, using the same #00 phillips head screwdriver remove the two 0.6mm screws which are one on each side of the tripod connection dip.

Step 3

The case can now be removed from the camera.
Using a blue opening tool start by lifting the back part of the case right where the tripod dip is. Lift until the back part of the case is released and can be easily removed
Next, using the same opening tool lift and push by the battery compartment as shown in the second picture. Do this until the front part of the case is released and can be easily removed.

The case can now be removed from the camera.

Using a blue opening tool start by lifting the back part of the case right where the tripod dip is. Lift until the back part of the case is released and can be easily removed

Next, using the same opening tool lift and push by the battery compartment as shown in the second picture. Do this until the front part of the case is released and can be easily removed.

Step 4

The LED diode to be replaced can be found in the front of the camera next to the zooming lens.
Desolder the LED to remove it from the motherboard

The LED diode to be replaced can be found in the front of the camera next to the zooming lens.

Desolder the LED to remove it from the motherboard

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    anna carolina von einem

Member since: 10/19/2016

450 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UMass Dartmouth, Team 3-4, Isaacson Fall 2016                        

                                                  Member of UMass Dartmouth, Team 3-4, Isaacson Fall 2016 



                    UMASSD-ISAACSON-F16S3G4                     


                                            3 Members                     


                                            10 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team