Ricoh Shotmaster 130Z Zooming Lens Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 15 minutes

Sections

Zooming Lens
6 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

BackRicoh Shotmaster 130Z
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Zooming Lens

Set the dials to “A” (Auto), and Off mode.
You will not be able to move these dials once the case has been opened.

Set the dials to “A” (Auto), and Off mode.

You will not be able to move these dials once the case has been opened.

1024

Step 2

Remove the 5 Phillips screws from the sides and the back.

Remove the 5 Phillips screws from the sides and the back.

Step 3

Remove the 5mm JIS #00 screws from the bottom of the camera.
Pay attention to the 6mm screws on the sides of the tripod slot, as they are a slightly different size from the rest of the screws. However, you still may use a J00 screwdriver to remove them.

Remove the 5mm JIS #00 screws from the bottom of the camera.

Pay attention to the 6mm screws on the sides of the tripod slot, as they are a slightly different size from the rest of the screws. However, you still may use a J00 screwdriver to remove them.

Step 4

Using an opening tool, lift the case of the tripod slot (on the bottom) until the back portion of the case is released.
Continue to use the the opening tool to insert it and lift right next to the strap of the camera.
This will release the front portion of the case.

Using an opening tool, lift the case of the tripod slot (on the bottom) until the back portion of the case is released.

Continue to use the the opening tool to insert it and lift right next to the strap of the camera.

This will release the front portion of the case.

Step 5

Use a JIS #0 screwdriver to remove the three marked screws found around the perimeter of the lens.

Use a JIS #0 screwdriver to remove the three marked screws found around the perimeter of the lens.

Step 6

Proceed to remove the two screws using a JIS #00 screwdriver.
Use tweezers to lift the lens off of the board.

Proceed to remove the two screws using a JIS #00 screwdriver.

Use tweezers to lift the lens off of the board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 12 other contributors

                    anna carolina von einem

Member since: 10/19/2016

450 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UMass Dartmouth, Team 3-4, Isaacson Fall 2016                        

                                                  Member of UMass Dartmouth, Team 3-4, Isaacson Fall 2016 



                    UMASSD-ISAACSON-F16S3G4                     


                                            3 Members                     


                                            10 Guides authored

Better Introduction#

Introduction#

What you need#

Team#

Better Introduction

Introduction

What you need

Team