Difficulty
Moderate
Steps
3
Time Required
5 - 10 minutes
Sections
1
- Outer Case
- 3 steps
Flags
0
BackRicoh Theta S
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Outer Case
- Wedge the spudger underneath the small plastic square located on the bottom of the device.
- Move the spudger to remove the plastic cover.
Wedge the spudger underneath the small plastic square located on the bottom of the device.
Move the spudger to remove the plastic cover.
1024
Step 2
- Remove the four 3-mm screws located on the bottom of the device. You will need to use the Phillips 00 screwdriver.
Remove the four 3-mm screws located on the bottom of the device. You will need to use the Phillips 00 screwdriver.
Step 3
- Insert the plastic opening tool in between the panels shown.
- Apply pressure to unlatch the 9 spring clips located around the perimeter of the device.
- Lift the panel from the device.
Insert the plastic opening tool in between the panels shown.
Apply pressure to unlatch the 9 spring clips located around the perimeter of the device.
Lift the panel from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Bradley Sutton
Member since: 11/07/2017
737 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
IUPUI, Team S3-G1, Harley Fall 2017
Member of IUPUI, Team S3-G1, Harley Fall 2017
IUPUI-HARLEY-F17S3G1
3 Members
4 Guides authored
Franco - May 6, 2018
Reply
Where can find spare part case?
Thanks
