Difficulty

Moderate

Steps

6

Time Required

                          6 - 8 minutes

Sections

1

  • Front Cover
  • 6 steps

Flags

3

Bullets!

Better coordination with markups and the color/type of bullets will help make this guide more clear!

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackRicoh YF-20 Super

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front Cover
  • Unscrew the seven indicated screws from the left, right, bottom, and back sides of the camera.

Unscrew the seven indicated screws from the left, right, bottom, and back sides of the camera.

1024

Step 2

  • Loosen the back cover from both the left and the right sides of the camera.
  • Remove back cover. The lid of the battery compartment may fall off because it is not attached to anything.

Loosen the back cover from both the left and the right sides of the camera.

Remove back cover. The lid of the battery compartment may fall off because it is not attached to anything.

Step 3

  • Open the film compartment.
  • Press your finger on top of the grey latch on the left side of the camera.

Open the film compartment.

Press your finger on top of the grey latch on the left side of the camera.

Step 4

  • Removing the film compartment door is optional. However, it may aid maneuverability in future steps.
  • Use a thin object like a toothpick or a small screwdriver to push down on the metal pin holding the film compartment door in place.
  • Use your fingers to completely remove the metal pin.
  • Remove the film compartment door.

Removing the film compartment door is optional. However, it may aid maneuverability in future steps.

Use a thin object like a toothpick or a small screwdriver to push down on the metal pin holding the film compartment door in place.

Use your fingers to completely remove the metal pin.

Remove the film compartment door.

Step 5

  • Using a thin shaft screwdriver, unscrew the two indicated screws within the film compartment.

Using a thin shaft screwdriver, unscrew the two indicated screws within the film compartment.

Step 6

  • Loosen the front cover from the left and right sides of the camera.
  • Remove the front cover.

Loosen the front cover from the left and right sides of the camera.

Remove the front cover.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors 


                    Eric Dazet

Member since: 04/10/2012

352 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team 6-21, Amido Spring 2012                        

                                                  Member of Cal Poly, Team 6-21, Amido Spring 2012 



                    CPSU-AMIDO-S12S6G21                     


                                            4 Members                     


                                            18 Guides authored