Ridgid Angle Grinder R10202 Motor Housing Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 - 20 minutes

Sections

Carbon Brush
2 steps
Motor Housing
6 steps

Flags

BackRidgid Angle Grinder R10202
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Carbon Brush

Use a flathead screwdriver to unscrew the brush holder cap.

Use a flathead screwdriver to unscrew the brush holder cap.

1024

Step 2

Using your fingers, gently lift the carbon brush up and out of its housing.
Repeat these steps to remove the other carbon brush on the opposing side.

Using your fingers, gently lift the carbon brush up and out of its housing.

Repeat these steps to remove the other carbon brush on the opposing side.

Step 3

              Motor Housing

Unscrew the side handle assembly from the gear housing assembly by hand.

Unscrew the side handle assembly from the gear housing assembly by hand.

Step 4

Unscrew the clamp nut and the backing flange from the output shaft assembly.
You can do this by hand or use a spanner wrench which should be provided in the manufacturers box.

Unscrew the clamp nut and the backing flange from the output shaft assembly.

You can do this by hand or use a spanner wrench which should be provided in the manufacturers box.

Step 5

Push in the guard lever and twist the guard until it aligns with the slots on the output shaft assembly.
There are two arrows that should align before you attempt to pull the pieces apart.

Push in the guard lever and twist the guard until it aligns with the slots on the output shaft assembly.

There are two arrows that should align before you attempt to pull the pieces apart.

Step 6

Lift the guard away from the output shaft assembly.

Lift the guard away from the output shaft assembly.

Step 7

Using a T25 Torx screwdriver, unscrew the four M5 X 28mm Torx screws.

Using a T25 Torx screwdriver, unscrew the four M5 X 28mm Torx screws.

Step 8

Grab the handle assembly and the gear housing assembly and gently pull apart.
Slowly pull the gear housing assembly out being careful not to damage the motor against the inside of the motor housing.

Grab the handle assembly and the gear housing assembly and gently pull apart.

Slowly pull the gear housing assembly out being careful not to damage the motor against the inside of the motor housing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Parker Massie

Member since: 01/10/2019

607 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Oregon Institute of Technology, Team S1-G2, Lancaster Winter 2019                        

                                                  Member of Oregon Institute of Technology, Team S1-G2, Lancaster Winter 2019 



                    OIT-LANCASTER-W19S1G2                     


                                            4 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team