Difficulty
Moderate
Steps
4
Time Required
10 - 20 minutes
Sections
1
- LED Light
- 4 steps
Flags
0
BackRidgid JobMax R8620 Series E
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
LED Light
- Pull the battery out of the case by hand before opening the device.
- Using a Torx T10 screwdriver, remove the nine 6mm screws on the drill cover.
- Lift off the outer casing.
Pull the battery out of the case by hand before opening the device.
Using a Torx T10 screwdriver, remove the nine 6mm screws on the drill cover.
Lift off the outer casing.
1024
Step 2
- Using a spudger or your fingers, remove the LED light from the groove in the handle.
Using a spudger or your fingers, remove the LED light from the groove in the handle.
Step 3
- Carefully remove the motor as well as the main board from the drill cover.
Carefully remove the motor as well as the main board from the drill cover.
Step 4
- Find the corresponding position of the LED line on the motherboard. If necessary, use tweezers to pull it out and replace it.
Find the corresponding position of the LED line on the motherboard. If necessary, use tweezers to pull it out and replace it.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Pengjian Zhou
Member since: 02/06/2019
533 Reputation
4 Guides authored
Badges:
7
+4 more badges
Team
UC Davis, Team S20-G1, Lore Winter 2019
Member of UC Davis, Team S20-G1, Lore Winter 2019
UCD-LORE-W19S20G1
3 Members
8 Guides authored
