Difficulty
Moderate
Steps
4
Time Required
10 - 15 minutes
Sections
1
- Motor
- 4 steps
Flags
0
BackRidgid JobMax R8620 Series E
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motor
- Pull the battery out of the case by hand before opening the device.
- Using a Torx T10 screwdriver, remove the nine 6mm screws on the drill cover.
- Lift off the outer casing.
Pull the battery out of the case by hand before opening the device.
Using a Torx T10 screwdriver, remove the nine 6mm screws on the drill cover.
Lift off the outer casing.
1024
Step 2
- Using a spudger or your fingers, remove the LED light from the groove in the handle.
Using a spudger or your fingers, remove the LED light from the groove in the handle.
Step 3
- Carefully remove the motor as well as the main board from the drill cover.
Carefully remove the motor as well as the main board from the drill cover.
Step 4
- Find the black and red wires from the motor.
- Remove the electrical tape using tweezers.
- Using a soldering iron, desolder the black and red wires from the motor.
- Refer to this helpful guide for tips on soldering/desoldering.
Find the black and red wires from the motor.
Remove the electrical tape using tweezers.
Using a soldering iron, desolder the black and red wires from the motor.
Refer to this helpful guide for tips on soldering/desoldering.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Pengjian Zhou
Member since: 02/06/2019
533 Reputation
4 Guides authored
Badges:
7
+4 more badges
Team
UC Davis, Team S20-G1, Lore Winter 2019
Member of UC Davis, Team S20-G1, Lore Winter 2019
UCD-LORE-W19S20G1
3 Members
8 Guides authored