Difficulty
Easy
Steps
4
Time Required
5 minutes
Sections
1
- Bearing
- 4 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackRidgid R2601
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Bearing
- Turn the sander upside down so that the base faces you.
- Remove the four 6.4 mm screws from the bottom of the base using a Torx T-25 screwdriver.
Turn the sander upside down so that the base faces you.
Remove the four 6.4 mm screws from the bottom of the base using a Torx T-25 screwdriver.
1024
Step 2
- Remove the base.
Remove the base.
Step 3
- Remove the 10 mm screw from the center of the bearing using a Torx T-20 screwdriver.
Remove the 10 mm screw from the center of the bearing using a Torx T-20 screwdriver.
Step 4
- Remove the bearing.
Remove the bearing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Gary Garner
Member since: 10/03/2019
274 Reputation
2 Guides authored
Badges:
4
+1 more badge
Team
The Citadel Military College of South Carolina, Team S1-G24, Eggleston Fall 2019
Member of The Citadel Military College of South Carolina, Team S1-G24, Eggleston Fall 2019
CMCSC-EGGLESTON-F19S1G24
2 Members
2 Guides authored
Dagan Larson - May 1, 2022
Reply
What is the bearing size?
