Difficulty
Moderate
Steps
6
Time Required
5 minutes
Sections
2
- Top Cover
- 2 steps
- Power Cord
- 4 steps
Flags
0
BackRidgid R2601
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Top Cover
- Remove the four M3.5 x 16 mm screws from the top cover using a Torx T10 screwdriver.
Remove the four M3.5 x 16 mm screws from the top cover using a Torx T10 screwdriver.
1024
Step 2
- Pull off the top cover.
Pull off the top cover.
Step 3
Power Cord
- Remove the two #6-19 x 15mm screws on the black retaining bracket using a Torx T15 screwdriver.
Remove the two #6-19 x 15mm screws on the black retaining bracket using a Torx T15 screwdriver.
Step 4
- Pop out and remove the black retaining bracket with your fingers.
Pop out and remove the black retaining bracket with your fingers.
Step 5
- Loosen the screws in the white terminal block with a small flathead screwdriver. Note that you do not need to fully unscrew and remove them.
Loosen the screws in the white terminal block with a small flathead screwdriver. Note that you do not need to fully unscrew and remove them.
Step 6
- Pull the wiring out from the white cover. The power cord can now be replaced by completing these steps in reverse.
Pull the wiring out from the white cover. The power cord can now be replaced by completing these steps in reverse.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Ellie Lott
Member since: 02/05/2019
461 Reputation
4 Guides authored
Badges:
5
+2 more badges
Team
UC Davis, Team S20-G3, Lore Winter 2019
Member of UC Davis, Team S20-G3, Lore Winter 2019
UCD-LORE-W19S20G3
3 Members
4 Guides authored