Difficulty
Moderate
Steps
3
Time Required
15 - 30 minutes
Sections
1
- Ball Bearing
- 3 steps
Flags
0
BackRidgid Belt Sander R2740
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Ball Bearing
- Orient the belt sander so that the AirGuard Technology logo is facing you.
- Remove the nine 19mm, two 51mm and one 32 mm screws that hold the cover into place.
- Remove the cover from the belt sander.
- Make sure you remember the correct placement of each screw.
Orient the belt sander so that the AirGuard Technology logo is facing you.
Remove the nine 19mm, two 51mm and one 32 mm screws that hold the cover into place.
Remove the cover from the belt sander.
Make sure you remember the correct placement of each screw.
1024
Step 2
- Remove the assembly armature from the belt sander.
- You may need to wiggle the assembly armature to remove it from the belt sander.
Remove the assembly armature from the belt sander.
You may need to wiggle the assembly armature to remove it from the belt sander.
Step 3
- Use a hammer to pry the ball bearing from the assembly armature.
- The ball bearing can be somewhat difficult to remove. You may need to apply WD-40 before removal.
Use a hammer to pry the ball bearing from the assembly armature.
The ball bearing can be somewhat difficult to remove. You may need to apply WD-40 before removal.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Cameron Smith
Member since: 01/10/2019
303 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
Oregon Institute of Technology, Team S1-G1, Lancaster Winter 2019
Member of Oregon Institute of Technology, Team S1-G1, Lancaster Winter 2019
OIT-LANCASTER-W19S1G1
4 Members
6 Guides authored
