Difficulty
Easy
Steps
3
Time Required
30 seconds
Sections
1
- Sand Belt
- 3 steps
Flags
0
BackRidgid Belt Sander R2740
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Sand belts need to be replaced after regular use of the device. Factors that could lead to belt deterioration include moisture, condensation, exposure to excessive cold and heat. The usable life of the sand belt depends on the material being sanded.
Before working on the RIDGID Belt Sander make sure the power tool is unplugged or disconnected from any power source. Failure to do so may result in electrocution or personal injury while removing the sand belt. Make sure to read through this guide for additional information before beginning the replacement of the RIDGID Belt Sander R2740 sand belt.
Step 1
Sand Belt
- Orient the device with the underside of the sander exposed and facing you.
Orient the device with the underside of the sander exposed and facing you.
1024
Step 2
- Pull the lever located on the right side of the sander all the way back.
Pull the lever located on the right side of the sander all the way back.
Step 3
- Gently remove the belt from the sander.
Gently remove the belt from the sander.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Brett Folsom
Member since: 10/02/2019
97 Reputation
1 Guide authored
Badges:
2
Team
The Citadel Military College of South Carolina, Team S2-G2, Eggleston Fall 2019
Member of The Citadel Military College of South Carolina, Team S2-G2, Eggleston Fall 2019
CMCSC-EGGLESTON-F19S2G2
3 Members
3 Guides authored
