Difficulty
Easy
Steps
4
Time Required
5 minutes
Sections
1
- Saw Blade
- 4 steps
Flags
0
BackRIDGID R32104
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Saw Blade
- Turn off your saw and unplug before starting.
- The RIDGID R32104 Saw did not come with a blade, so paper was used to mime the actions needed.
- Place the Worm Drive Saw on a sturdy surface.
- The blade is located within its upper blade guard and lower swing guard assembly.
Turn off your saw and unplug before starting.
The RIDGID R32104 Saw did not come with a blade, so paper was used to mime the actions needed.
Place the Worm Drive Saw on a sturdy surface.
The blade is located within its upper blade guard and lower swing guard assembly.
1024
Step 2
- Using a H-6 mm Allen Key, remove the 3/8 - 16 UNC LH screw, washer, and outer blade washer that fixes the blade in place.
- In order to unscrew this, you must turn the screw clockwise to loosen it.
Using a H-6 mm Allen Key, remove the 3/8 - 16 UNC LH screw, washer, and outer blade washer that fixes the blade in place.
In order to unscrew this, you must turn the screw clockwise to loosen it.
Step 3
- Adjust the lower swing guard to properly grab the blade.
Adjust the lower swing guard to properly grab the blade.
Step 4
- Remove the blade by gingerly grabbing towards its center, preventing any injury from occurring.
Remove the blade by gingerly grabbing towards its center, preventing any injury from occurring.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Lucas Pimentel
Member since: 04/02/2019
1,010 Reputation
8 Guides authored
Badges:
8
+5 more badges
Team
UMass Dartmouth, Team S5-G1, Julie Spring 2019
Member of UMass Dartmouth, Team S5-G1, Julie Spring 2019
UMASSD-JULIE-S19S5G1
4 Members
8 Guides authored
