Difficulty
Very easy
Steps
5
Time Required
3 - 4 minutes
Sections
1
- Saw Blade
- 5 steps
Flags
0
BackRidgid Table Saw R4021 (2017)
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Saw Blade
- Remove the top panel to access the saw blade.
- Ensure any debris is cleared from the blade area.
Remove the top panel to access the saw blade.
Ensure any debris is cleared from the blade area.
1024
Step 2
- Remove the two included wrenches located on the right side of the unit.
Remove the two included wrenches located on the right side of the unit.
Step 3
- Fit the larger wrench around the nut on saw blade.
- Fasten the smaller wrench to the screw coming through the blade.
- Twist the bigger lever counter-clockwise while holding the smaller wrench in order to remove the nut.
Fit the larger wrench around the nut on saw blade.
Fasten the smaller wrench to the screw coming through the blade.
Twist the bigger lever counter-clockwise while holding the smaller wrench in order to remove the nut.
Step 4
- Remove the saw blade by tilting it away from the well wall.
- Use caution when handling the saw blade.
Remove the saw blade by tilting it away from the well wall.
Use caution when handling the saw blade.
Step 5
- Place the new blade on the screw the same way the other blade was removed.
- You can put the old blade in the new packaging to ensure safety.
Place the new blade on the screw the same way the other blade was removed.
You can put the old blade in the new packaging to ensure safety.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Obelia Abarca
Member since: 09/17/2021
303 Reputation
2 Guides authored
Badges:
3
Team
York University, Team C-1, O'Regan Fall 2021
Member of York University, Team C-1, O'Regan Fall 2021
YORK-O'REGAN-F21SCG1
1 Member
2 Guides authored
