Difficulty

Moderate

Steps

5

Time Required

                          45 minutes - 1 hour

Sections

2

  • Housing Assembly
  • 4 steps
  • Motor
  • 1 step

Flags

0

  • BackRidgid R82005

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Housing Assembly
  • Eject the battery from the drill.
  • Unscrew the seven M3x15.3mm screws, with the 2mm hex screwdriver bit, that secures the Housing Assembly.

Eject the battery from the drill.

Unscrew the seven M3x15.3mm screws, with the 2mm hex screwdriver bit, that secures the Housing Assembly.

1024

Step 2

  • Push the metallic Housing Connecting clip out with flat side of the plastic opening tool.
  • Eject battery before attempting this step.

Push the metallic Housing Connecting clip out with flat side of the plastic opening tool.

Eject battery before attempting this step.

Step 3

  • Remove the top half of the Housing Assembly.

Remove the top half of the Housing Assembly.

Step 4

  • Grasp carefully the top and bottom of drill components.
  • LED light needs to be manually removed.
  • Lift and transfer, as a whole, the drill components from the old housing assembly to the new housing.
  • Make sure all drill components fit properly in the grooves of new Housing Assembly.

Grasp carefully the top and bottom of drill components.

LED light needs to be manually removed.

Lift and transfer, as a whole, the drill components from the old housing assembly to the new housing.

Make sure all drill components fit properly in the grooves of new Housing Assembly.

Step 5

              Motor
  • Push the two pins through the motor assembly.
  • We used an Alan wrench to push the pins through, but any small tool will do.
  • Unsolder the wires from the back of the motor to free the motor from the trigger assembly.
  • To learn how to solder, check out the How to Solder and Desolder Connections guide.
  • Make sure all drill components fit properly in the grooves of the Housing Assembly.

Push the two pins through the motor assembly.

We used an Alan wrench to push the pins through, but any small tool will do.

Unsolder the wires from the back of the motor to free the motor from the trigger assembly.

To learn how to solder, check out the How to Solder and Desolder Connections guide.

Make sure all drill components fit properly in the grooves of the Housing Assembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 3 other contributors 


                    Andrew McPherson

Member since: 02/14/2019

443 Reputation

                                      3 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges

Team

                       USF Tampa, Team S1-G2, Leahy Spring 2019                        

                                                  Member of USF Tampa, Team S1-G2, Leahy Spring 2019 



                    USFT-LEAHY-S19S1G2                     


                                            4 Members                     


                                            10 Guides authored