Difficulty
Easy
Steps
3
Time Required
15 - 20 minutes
Sections
1
- Direction of Rotation Selector
- 3 steps
Flags
0
BackRIDGID R860052
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Direction of Rotation Selector
- Remove the battery from the drill before you begin.
- Use a T10 Torx screwdriver to remove the ten screws on the information label side of the drill.
- These ten screws are 19 mm long.
Remove the battery from the drill before you begin.
Use a T10 Torx screwdriver to remove the ten screws on the information label side of the drill.
These ten screws are 19 mm long.
1024
Step 2
- Lift off and remove the cover with the informational label.
Lift off and remove the cover with the informational label.
Step 3
- Lift up the switch assembly.
- Unhook the rotation selector from the drill cover and replace with a new one.
Lift up the switch assembly.
Unhook the rotation selector from the drill cover and replace with a new one.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Anna Wu
Member since: 02/04/2019
273 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
UC Davis, Team S18-G4, Lore Winter 2019
Member of UC Davis, Team S18-G4, Lore Winter 2019
UCD-LORE-W19S18G4
3 Members
6 Guides authored
