Difficulty
Difficult
Steps
5
Time Required
40 - 50 minutes
Sections
1
- Motor
- 5 steps
Flags
0
BackRIDGID R860052
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motor
- Remove the battery from the drill before you begin.
- Use a T10 Torx screwdriver to remove the ten screws on the information label side of the drill.
- These ten screws are 19 mm long.
Remove the battery from the drill before you begin.
Use a T10 Torx screwdriver to remove the ten screws on the information label side of the drill.
These ten screws are 19 mm long.
1024
Step 2
- Lift off and remove the cover with the informational label.
Lift off and remove the cover with the informational label.
Step 3
- Remove the switch assembly, chuck, and motor from all drill covers.
Remove the switch assembly, chuck, and motor from all drill covers.
Step 4
- Twist the chuck and motor in the opposite direction and gently pull them apart.
Twist the chuck and motor in the opposite direction and gently pull them apart.
Step 5
- Desolder the black and red wires from the motor.
- Replace motor and resolder the black and red wires back onto the motor.
- Be aware of the heat level of the metal part on the soldering tool.
Desolder the black and red wires from the motor.
Replace motor and resolder the black and red wires back onto the motor.
Be aware of the heat level of the metal part on the soldering tool.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Andrea Hernandez
Member since: 02/05/2019
204 Reputation
1 Guide authored
Badges:
6
+3 more badges
Team
UC Davis, Team S18-G4, Lore Winter 2019
Member of UC Davis, Team S18-G4, Lore Winter 2019
UCD-LORE-W19S18G4
3 Members
6 Guides authored
