Difficulty
Difficult
Steps
4
Time Required
30 - 40 minutes
Sections
1
- Switch Assembly
- 4 steps
Flags
0
BackRIDGID R860052
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Switch Assembly
- Remove the battery from the drill before you begin.
- Use a T10 Torx screwdriver to unscrew the ten screws on the information label side of the drill.
- These ten screws are 19 mm long.
Remove the battery from the drill before you begin.
Use a T10 Torx screwdriver to unscrew the ten screws on the information label side of the drill.
These ten screws are 19 mm long.
1024
Step 2
- Lift off and remove the cover with the informational label.
Lift off and remove the cover with the informational label.
Step 3
- Remove the switch assembly, chuck, and motor from all drill covers.
- Check if all wires are connected to the switch assembly and motor as illustrated in the image.
Remove the switch assembly, chuck, and motor from all drill covers.
Check if all wires are connected to the switch assembly and motor as illustrated in the image.
Step 4
- To replace the switch assembly, desolder the black and red wires and replace with a new switch assembly.
- Be aware of the heat level of the metal part on the soldering tool.
To replace the switch assembly, desolder the black and red wires and replace with a new switch assembly.
Be aware of the heat level of the metal part on the soldering tool.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Anna Wu
Member since: 02/04/2019
273 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
UC Davis, Team S18-G4, Lore Winter 2019
Member of UC Davis, Team S18-G4, Lore Winter 2019
UCD-LORE-W19S18G4
3 Members
6 Guides authored
