Ring Stick Up Cam Camera Replacement Repair Guide

Difficulty

Moderate

Steps

13

Time Required

                          20 - 40 minutes            

Sections

2

• Battery
• 6 steps
• Camera
• 7 steps

Flags

0

• BackRing Stick Up Cam

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Remove the six 6mm Phillips #00 screws from the back of the device.

Remove the six 6mm Phillips #00 screws from the back of the device.

1024

Step 2

• Pry off the aluminum plate using a plastic opening tool.

Pry off the aluminum plate using a plastic opening tool.

Step 3

• Remove the two 6mm Phillips #00 screws that were under the aluminum plate.

Remove the two 6mm Phillips #00 screws that were under the aluminum plate.

Step 4

• Pry off the back cover using a plastic opening tool.

Pry off the back cover using a plastic opening tool.

Step 5

• Disconnect the battery power leads using a plastic opening tool.

Disconnect the battery power leads using a plastic opening tool.

Step 6

• Use a plastic opening tool to loosen the adhesive holding the battery in place and remove the battery by hand.

Use a plastic opening tool to loosen the adhesive holding the battery in place and remove the battery by hand.

Step 7

              Camera               

• Remove the three silver 6mm Phillips #00 screws holding the motherboard in the device.

Remove the three silver 6mm Phillips #00 screws holding the motherboard in the device.

Step 8

• Disconnect the ribbon connector shown in the photo.

Disconnect the ribbon connector shown in the photo.

Step 9

• Remove the motherboard from the device by hand.

Remove the motherboard from the device by hand.

Step 10

• Remove the two black 5mm Phillips #00 screws holding the camera board into the device.
• Remove the single silver 10mm Phillips #00 screw holding the camera board into the device.

Remove the two black 5mm Phillips #00 screws holding the camera board into the device.

Remove the single silver 10mm Phillips #00 screw holding the camera board into the device.

Step 11

• Remove the three plastic spacers shown in the photo by hand.

Remove the three plastic spacers shown in the photo by hand.

Step 12

• Carefully disconnect the camera board from the daughterboard by sliding a plastic opening tool between the camera board and the daughterboard.

Carefully disconnect the camera board from the daughterboard by sliding a plastic opening tool between the camera board and the daughterboard.

Step 13

• Lift the camera board out of the housing using your hand.

Lift the camera board out of the housing using your hand.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 3 other contributors 

                    Ao Li                     

Member since: 02/06/2019

245 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       UC Davis, Team S18-G3, Lore Winter 2019                        

                                                  Member of UC Davis, Team S18-G3, Lore Winter 2019 



                    UCD-LORE-W19S18G3                     


                                            3 Members                     


                                            8 Guides authored                     

Javier Casas - Jul 8, 2019

Reply

Where can I purchase a new lens?

Mete Doguoglu - Oct 26, 2021

Reply

Any ideas where to get a new lens?