Difficulty
Moderate
Steps
4
Time Required
10 minutes
Sections
2
- Base Plate
- 2 steps
- Power Cable
- 2 steps
Flags
0
BackRival CM4015
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Base Plate
- Remove the three 16 mm tri-point screws from the base plate.
Remove the three 16 mm tri-point screws from the base plate.
1024
Step 2
- Remove the base plate by pressing the plastic body away from the metal plate with your thumbs.
Remove the base plate by pressing the plastic body away from the metal plate with your thumbs.
Step 3
Power Cable
- Remove the two 8mm Phillips screws from the plastic body.
Remove the two 8mm Phillips screws from the plastic body.
Step 4
- Pull the cord and cut the black and red wires across the black heat shrink.
- Be careful when soldering the new power cable.
Pull the cord and cut the black and red wires across the black heat shrink.
Be careful when soldering the new power cable.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Luis Villalpando
Member since: 10/06/2016
113 Reputation
1 Guide authored
Badges:
6
+3 more badges
Team
Cal Poly, Team 10-6, Livingston Fall 2016
Member of Cal Poly, Team 10-6, Livingston Fall 2016
CPSU-LIVINGSTON-F16S10G6
5 Members
6 Guides authored
