Rocketfish Rf Whtib A Receiver Led Light Chip Replacement Repair Guide

Difficulty

Easy

Steps

6

Time Required

                          10 - 15 minutes            

Sections

2

• How to Open the Rocketfish RF-WHTIB-A Receiver
• 3 steps
• Receiver LED Light Chip
• 3 steps

Flags

Grammar Police

Embrace your inner English teacher and help improve this guide’s grammar!

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

• BackRocketfish RF-WHTIB-A

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              How to Open the Rocketfish RF-WHTIB-A Receiver               

• Remove the 4 rubber tabs on the bottom side of the receiver.

Remove the 4 rubber tabs on the bottom side of the receiver.

1024

Step 2

• Unscrew the four 12 mm screws on the bottom side of the receiver.
• Use a Phillips #1 screwdriver for this step.

Unscrew the four 12 mm screws on the bottom side of the receiver.

Use a Phillips #1 screwdriver for this step.

Step 3

• Remove top casing from the receiver.
• The receiver top casing is difficult to remove. Internal clasps may have to be broken in order to remove the top casing (this will not effect the device’s function)

Remove top casing from the receiver.

The receiver top casing is difficult to remove. Internal clasps may have to be broken in order to remove the top casing (this will not effect the device’s function)

Step 4

              Receiver LED Light Chip               

• One 10 mm screw is securing the LED 14.14 chip.
• Unscrew the chip.
• Use a Phillips #1 Screwdriver for this step.

One 10 mm screw is securing the LED 14.14 chip.

Unscrew the chip.

Use a Phillips #1 Screwdriver for this step.

Step 5

• Using your fingers, gently pull the LED plug out of the mother board.

Using your fingers, gently pull the LED plug out of the mother board.

Step 6

• Gently feed the LED wire under the power supply to completely remove it from the sender.
• Remove the faulty LED 14.14 chip from the receiver.
• You may want to use the tweezers to help pull the LED wire out from beneath the power supply.

Gently feed the LED wire under the power supply to completely remove it from the sender.

Remove the faulty LED 14.14 chip from the receiver.

You may want to use the tweezers to help pull the LED wire out from beneath the power supply.

To reassemble your device with the new LED light chip, follow these instructions in reverse order.

Once the receiver has been put back together, plug in the device and initiate the connection mode between the sender and receiver to ensure the new LED light chip has been properly assembled.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Caitlin Charlton                     

Member since: 03/22/2015

735 Reputation

                                      6 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges                           

Team

                       Baylor, Team 4-2, Williams Spring 2015                        

                                                  Member of Baylor, Team 4-2, Williams Spring 2015 



                    BU-WILLIAMS-S15S4G2                     


                                            3 Members                     


                                            6 Guides authored                     

sean moore - Mar 27, 2021

Reply

Where do I get the chip???

bugsyc26 - Nov 18, 2021

Reply

where do I get chip?