Rocketfish Rf Wsp313 Speaker Replacement Repair Guide

Difficulty

Moderate

Steps

13

Time Required

                          30 - 35 minutes            

Sections

1

• Speaker
• 13 steps

Flags

0

• BackRocketfish RF-WSP313

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Speaker               

• Using the metal spudger, remove the outer cap from the top of the device.

Using the metal spudger, remove the outer cap from the top of the device.

1024

Step 2

• Using a Phillips # 1 screwdriver, remove the four 1.1 cm flathead screws attaching the metal ring to the top of the device.

Using a Phillips # 1 screwdriver, remove the four 1.1 cm flathead screws attaching the metal ring to the top of the device.

Step 3

• Remove the ring and set aside.

Remove the ring and set aside.

Step 4

• Using the metal spudger, remove the cap from the bottom of the device.

Using the metal spudger, remove the cap from the bottom of the device.

Step 5

• Using a Phillips # 1 screwdriver, remove the four 1.1 sm screws attaching the metal ring to the bottom of the device.

Using a Phillips # 1 screwdriver, remove the four 1.1 sm screws attaching the metal ring to the bottom of the device.

Step 6

Step 7

• Using a Phillips # 1 screwdriver, remove the four 1 cm screws from the outside panel. You will do this for each panel; it does not matter which side you start with.

Using a Phillips # 1 screwdriver, remove the four 1 cm screws from the outside panel. You will do this for each panel; it does not matter which side you start with.

Step 8

• Using the metal spudger, pry off the side panel. Repeat this step on the other side panel.

Using the metal spudger, pry off the side panel. Repeat this step on the other side panel.

Step 9

• Using a Phillips #1 screwdriver, remove the four 1.1 cm flathead screws from the side of the device. Repeat this step on the other side of the device.

Using a Phillips #1 screwdriver, remove the four 1.1 cm flathead screws from the side of the device. Repeat this step on the other side of the device.

Step 10

• Using the metal spudger, open the device.

Using the metal spudger, open the device.

Step 11

• Using your fingers (or a pair of tweezers), disconnect the speaker cord from its socket.

Using your fingers (or a pair of tweezers), disconnect the speaker cord from its socket.

Step 12

• Using a Phillips #1 screwdriver, remove the four 1.2 cm pan head screws surrounding the speaker.

Using a Phillips #1 screwdriver, remove the four 1.2 cm pan head screws surrounding the speaker.

Step 13

• Remove the speaker from the device.

Remove the speaker from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Kara Falknor                     

Member since: 01/25/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Washington State, Team 1-50, Staggers Spring 2017                        

                                                  Member of Washington State, Team 1-50, Staggers Spring 2017 



                    WSU-STAGGERS-S17S1G50                     


                                            2 Members                     


                                            1 Guide authored