Roll Pin Installation Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Roll Pin Installation
5 steps

Flags

BackElectric Eel Drain Cleaner Z5K-1/2IC75-AF (2013)
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Install the Roll Pin

Use a vise to compress the roll pin until there is no longer space in the roll pin’s slot.

Use a vise to compress the roll pin until there is no longer space in the roll pin’s slot.

1024

Step 2

Use a dead blow hammer or mallet to tap down the bearing carrier onto the roll pin until the pin just begins to peek into the bearing channel.
Ensure you are using the correct bearing carrier for this step. The top bearing assembly uses the shorter carrier, while the two lower bearing assemblies use the longer carrier.

Use a dead blow hammer or mallet to tap down the bearing carrier onto the roll pin until the pin just begins to peek into the bearing channel.

Ensure you are using the correct bearing carrier for this step. The top bearing assembly uses the shorter carrier, while the two lower bearing assemblies use the longer carrier.

Step 3

Insert a bearing and the bearing spacer into the bearing channel.
Ensure that the bearing and spacer are aligned with the roll pin and hole in the bearing carrier.

Insert a bearing and the bearing spacer into the bearing channel.

Ensure that the bearing and spacer are aligned with the roll pin and hole in the bearing carrier.

Step 4

Continue to tap down the bearing carrier until the bearing and spacer are fully secured around the roll pin.
You will need to unclamp and reposition the roll pin upwards to continue tapping it into the bearing carrier. Do this as many times as is necessary to sufficiently support the roll pin.

Continue to tap down the bearing carrier until the bearing and spacer are fully secured around the roll pin.

You will need to unclamp and reposition the roll pin upwards to continue tapping it into the bearing carrier. Do this as many times as is necessary to sufficiently support the roll pin.

Step 5

Use a roll pin punch to finish seating the roll pin into place.
Place a piece of cloth or mat on top of the vise below the bearing carrier to prevent marring the outer surface of the bearing carrier.
Before moving to the next step, ensure the roll pin is fully seated and completely within the bearing carrier. A slightly exposed roll pin may damage the inside of your feeder body when the bearing carrier assembly is being installed.

Use a roll pin punch to finish seating the roll pin into place.

Place a piece of cloth or mat on top of the vise below the bearing carrier to prevent marring the outer surface of the bearing carrier.

Before moving to the next step, ensure the roll pin is fully seated and completely within the bearing carrier. A slightly exposed roll pin may damage the inside of your feeder body when the bearing carrier assembly is being installed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Tarun Thiruma

Member since: 11/20/2019

31,630 Reputation

                                      133 Guides authored                  



                       Badges:
                       32







                                                        +29 more badges

Introduction#

What you need#

#

#

#

#

#

#

#

Introduction

What you need