Difficulty

Moderate

Steps

8

Time Required

                          4 - 6 minutes

Sections

2

  • Saw Casing
  • 5 steps
  • Power Cord
  • 3 steps

Flags

0

  • BackRotoZip Rebel REB01 Type 2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Saw Casing
  • Unplug the saw before attempting any of the replacement guides.
  • Orient the saw so that the handle is closest to you and the saw end points towards the left.

Unplug the saw before attempting any of the replacement guides.

Orient the saw so that the handle is closest to you and the saw end points towards the left.

1024

Step 2

  • Push down on the grey lock on the right side of the handle to unlock it.
  • Pull the handle to detach it from the saw.

Push down on the grey lock on the right side of the handle to unlock it.

Pull the handle to detach it from the saw.

Step 3

  • Lift the black lock at the tip of the saw to unlock the depth gauge.
  • Pull the depth gauge to detach it from the saw.

Lift the black lock at the tip of the saw to unlock the depth gauge.

Pull the depth gauge to detach it from the saw.

Step 4

  • Rotate the device so that the bottom of the saw is facing upwards.
  • Remove the six 20mm screws with a 6mm flathead screwdriver.

Rotate the device so that the bottom of the saw is facing upwards.

Remove the six 20mm screws with a 6mm flathead screwdriver.

Step 5

  • Cut through the stickers on the right and left sides of the saw using a metal spudger.
  • Pull off the top half of the casing.

Cut through the stickers on the right and left sides of the saw using a metal spudger.

Pull off the top half of the casing.

Step 6

              Power Cord
  • Remove the two 14 mm screws on the plastic plate holding the power cord with a flat head screwdriver.
  • Lift off the plastic plate holding the power cord with a tweezer.

Remove the two 14 mm screws on the plastic plate holding the power cord with a flat head screwdriver.

Lift off the plastic plate holding the power cord with a tweezer.

Step 7

  • Pull the switchboard out slowly.
  • The power switch will also come out. Set it on the side.

Pull the switchboard out slowly.

The power switch will also come out. Set it on the side.

Step 8

  • Pinch the two white clips with your thumb while simultaneously removing the black and white wires.
  • Remove the power cord from the saw.
  • When reassembling, make sure to plug the black wire into the top clip.

Pinch the two white clips with your thumb while simultaneously removing the black and white wires.

Remove the power cord from the saw.

When reassembling, make sure to plug the black wire into the top clip.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Ezzeddeen Gazali

Member since: 10/06/2016

69 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 4-4, Livingston Fall 2016                        

                                                  Member of Cal Poly, Team 4-4, Livingston Fall 2016 



                    CPSU-LIVINGSTON-F16S4G4                     


                                            4 Members                     


                                            5 Guides authored