Difficulty

Moderate

Steps

9

Time Required

                          15 minutes

Sections

3

  • Battery
  • 2 steps
  • Bumper
  • 3 steps
  • Side Brush Motor
  • 4 steps

Flags

0

  • BackRydis H68 Pro

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Flip the vacuum over so that the wheels are facing you.
  • Use a Phillips #1 screwdriver to remove the four 10mm screws that surround the battery cover.

Flip the vacuum over so that the wheels are facing you.

Use a Phillips #1 screwdriver to remove the four 10mm screws that surround the battery cover.

1024

Step 2

  • Lift up the battery cover to reveal the battery.
  • Remove the battery.

Lift up the battery cover to reveal the battery.

Remove the battery.

Step 3

              Bumper
  • Remove the eight 10 mm Phillips #1 screws.

Remove the eight 10 mm Phillips #1 screws.

Step 4

  • Hold the front bumper and pull it off.
  • It requires a lot of force to pull the bumper off.

Hold the front bumper and pull it off.

It requires a lot of force to pull the bumper off.

Step 5

  • Pry off the back bumper by going around the entire top of the bumper with the metal spudger.

Pry off the back bumper by going around the entire top of the bumper with the metal spudger.

Step 6

              Side Brush Motor
  • Begin by unscrewing the 2 10mm screws using a Phillips #1 screwdriver.
  • Unlatch the latches indicated. It can be easily done with your finger.
  • Once unsecured, the covering for the sensors can easily be removed allowing access to the sensors.
  • The reason for these first few steps is to avoid damaging the signal wires for the sensor.

Begin by unscrewing the 2 10mm screws using a Phillips #1 screwdriver.

Unlatch the latches indicated. It can be easily done with your finger.

Once unsecured, the covering for the sensors can easily be removed allowing access to the sensors.

The reason for these first few steps is to avoid damaging the signal wires for the sensor.

Step 7

  • This step just shows you how everything looks after the previous steps were completed.
  • There are sensors on both the left and right side. This can be done for either side.

This step just shows you how everything looks after the previous steps were completed.

There are sensors on both the left and right side. This can be done for either side.

Step 8

  • Unscrew the five 10mm screws using a Phillips #1 screwdriver.

Unscrew the five 10mm screws using a Phillips #1 screwdriver.

Step 9

  • The side brush motor can now be removed by lifting it up.

The side brush motor can now be removed by lifting it up.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    jude auguste

Member since: 02/15/2017

108 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       USFT-Lacy-S17S005G2                        

                                                  Member of USFT-Lacy-S17S005G2 



                    Meetup                     


                                            4 Members                     


                                            10 Guides authored