Difficulty
Moderate
Steps
6
Time Required
25 minutes
Sections
2
- Carbon Brush
- 2 steps
- Driveshaft
- 4 steps
Flags
0
BackRYOBI AG454
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Carbon Brush
- Remove the brush caps from each side of the body using the 4 mm flat head screwdriver.
Remove the brush caps from each side of the body using the 4 mm flat head screwdriver.
1024
Step 2
- Remove the carbon brushes.
Remove the carbon brushes.
Step 3
Driveshaft
- Remove the two carbon brushes from both sides of the device.
Remove the two carbon brushes from both sides of the device.
Step 4
- Remove the four 20mm screws that secures the gear box using a Phillips #1 screwdriver.
Remove the four 20mm screws that secures the gear box using a Phillips #1 screwdriver.
Step 5
- Seperate the gear box case from body.
Seperate the gear box case from body.
Step 6
- Pull out drive shaft and remove it from the device.
Pull out drive shaft and remove it from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Erica Faulkner
Member since: 09/18/2019
716 Reputation
5 Guides authored
Badges:
5
+2 more badges
Team
Embry-Riddle Aeronautical University, Team S12-G4, Lamothe Fall 2019
Member of Embry-Riddle Aeronautical University, Team S12-G4, Lamothe Fall 2019
ERAU-LAMOTHE-F19S12G4
4 Members
5 Guides authored
