Difficulty
Difficult
Steps
12
Time Required
45 minutes
Sections
1
- Motor
- 12 steps
Flags
0
BackRyobi CSB125
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motor
- Place the saw on a flat surface with the blade facing up.
- Make sure that the saw is unplugged from any power source.
Place the saw on a flat surface with the blade facing up.
Make sure that the saw is unplugged from any power source.
1024
Step 2
- Remove the bumper by using the T20 torx screwdriver to loosen the M5 x 20mm screw.
Remove the bumper by using the T20 torx screwdriver to loosen the M5 x 20mm screw.
Step 3
- Use the 7”/32 allen key to loosen the 5/16-18 x 9/16 in. blade screw.
Use the 7”/32 allen key to loosen the 5/16-18 x 9/16 in. blade screw.
Step 4
- Remove the 5/16-18 x 9/16 in. blade screw, spring washer, the outer blade washer, the blade, and the inner blade washer.
Remove the 5/16-18 x 9/16 in. blade screw, spring washer, the outer blade washer, the blade, and the inner blade washer.
Step 5
- Use the #2 Phillip screwdriver to remove the four M4x16mm screws shown.
- You will need to rotate the protective shell around in order to access them.
Use the #2 Phillip screwdriver to remove the four M4x16mm screws shown.
You will need to rotate the protective shell around in order to access them.
Step 6
- Remove the lower blade guard support assembly from the rest of the saw.
Remove the lower blade guard support assembly from the rest of the saw.
Step 7
- Flip the saw over and place the saw down on a flat surface with the motor facing up.
Flip the saw over and place the saw down on a flat surface with the motor facing up.
Step 8
- Use the Phillips #2 screwdriver to remove the five M4x16mm screws.
Use the Phillips #2 screwdriver to remove the five M4x16mm screws.
Step 9
- Use the Phillips #2 screwdriver to remove the two M45x35mm screws.
Use the Phillips #2 screwdriver to remove the two M45x35mm screws.
Step 10
- Use the Phillips #2 screwdriver to remove the two M4x16mm screws holding down the end cover.
- Pull off the end cover.
Use the Phillips #2 screwdriver to remove the two M4x16mm screws holding down the end cover.
Pull off the end cover.
Step 11
- Use the Phillips #2 screwdriver to remove the M45x35mm screw holding down the motor housing.
Use the Phillips #2 screwdriver to remove the M45x35mm screw holding down the motor housing.
Step 12
- Remove the motor housing for access to the internal motor components.
Remove the motor housing for access to the internal motor components.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 1 other contributor
Curtis Melo
Member since: 10/31/2019
1,039 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
UMass Dartmouth, Team S2-G1, Barthe Fall 2019
Member of UMass Dartmouth, Team S2-G1, Barthe Fall 2019
UMASSD-BARTHE-F19S2G1
3 Members
5 Guides authored
