Ryobi Csb125 Power Cord Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          15 minutes            

Sections

1

• Power Cord
• 5 steps

Flags

Missed a Step

Oops! This guide is currently missing some important steps.

• BackRyobi CSB125

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Power Cord               

• Place the saw down on a flat surface with the motor facing up.
• Make sure that the saw is unplugged from any power source.

Place the saw down on a flat surface with the motor facing up.

Make sure that the saw is unplugged from any power source.

1024

Step 2

• Use the Phillips #2 screwdriver to remove the five M4x16mm screws.

Use the Phillips #2 screwdriver to remove the five M4x16mm screws.

Step 3

• Use the Phillips #2 screwdriver to remove the two M45x35mm screws.

Use the Phillips #2 screwdriver to remove the two M45x35mm screws.

Step 4

• To remove the plug from the saw you will need to disconnect the two wires that come from the plug.
• Remove the black wire by unscrewing it from the trigger switch using the Phillips #2 screwdriver.
• Remove the white wire by twisting off the plastic wire nut to separate the two white wires.

To remove the plug from the saw you will need to disconnect the two wires that come from the plug.

Remove the black wire by unscrewing it from the trigger switch using the Phillips #2 screwdriver.

Remove the white wire by twisting off the plastic wire nut to separate the two white wires.

Step 5

• Remove the plug from the saw.
• You may have to use the wire strippers to expose the copper on the new plug.
• It is important that the wires are properly run in their tracks. Failure to do so could result in pinching a wire, which could damage the plug.

Remove the plug from the saw.

You may have to use the wire strippers to expose the copper on the new plug.

It is important that the wires are properly run in their tracks. Failure to do so could result in pinching a wire, which could damage the plug.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                                      with 1 other contributor 

                    Curtis Melo                     

Member since: 10/31/2019

1,039 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       UMass Dartmouth, Team S2-G1, Barthe Fall 2019                        

                                                  Member of UMass Dartmouth, Team S2-G1, Barthe Fall 2019 



                    UMASSD-BARTHE-F19S2G1                     


                                            3 Members                     


                                            5 Guides authored