Difficulty
Moderate
Steps
5
Time Required
15 minutes
Sections
1
- Trigger
- 5 steps
Flags
0
BackRyobi CSB125
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Trigger
- Place the saw down on a flat surface with the motor facing up.
- Make sure that the saw is unplugged from any power source.
Place the saw down on a flat surface with the motor facing up.
Make sure that the saw is unplugged from any power source.
1024
Step 2
- Use the Phillips #2 screwdriver to remove the five M4x16mm screws.
Use the Phillips #2 screwdriver to remove the five M4x16mm screws.
Step 3
- Use the Phillips #2 screwdriver to remove the two M45x35mm screws.
Use the Phillips #2 screwdriver to remove the two M45x35mm screws.
Step 4
- Disconnect the two black wires by unscrewing them from the trigger switch using the Phillips #2 screwdriver.
Disconnect the two black wires by unscrewing them from the trigger switch using the Phillips #2 screwdriver.
Step 5
- Remove the trigger from the saw.
- You may have to use the wire strippers to the copper on the new plug.
- It is important that the wires are properly run in their tracks. Failure to do so could result in pinching a wire, which could damage the plug.
Remove the trigger from the saw.
You may have to use the wire strippers to the copper on the new plug.
It is important that the wires are properly run in their tracks. Failure to do so could result in pinching a wire, which could damage the plug.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 1 other contributor
Curtis Melo
Member since: 10/31/2019
1,039 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
UMass Dartmouth, Team S2-G1, Barthe Fall 2019
Member of UMass Dartmouth, Team S2-G1, Barthe Fall 2019
UMASSD-BARTHE-F19S2G1
3 Members
5 Guides authored
