Difficulty
Easy
Steps
6
Time Required
5 - 10 minutes
Sections
2
- Battery
- 2 steps
- Bit-Holder
- 4 steps
Flags
0
BackRyobi P235
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Push in both push tabs on the battery at the same time.
- They are located below the green housing and are in the middle on both sides of the battery.
Push in both push tabs on the battery at the same time.
They are located below the green housing and are in the middle on both sides of the battery.
1024
Step 2
- Pull the battery away from the drill housing while holding in both tabs.
Pull the battery away from the drill housing while holding in both tabs.
Step 3
Bit-Holder
- Use a Phillips #2 screwdriver to remove the eight 16 mm screws that secure the housing.
Use a Phillips #2 screwdriver to remove the eight 16 mm screws that secure the housing.
Step 4
- Use a T20 Torx screwdriver to remove the four 25.4 mm screws that secure the front of the housing.
Use a T20 Torx screwdriver to remove the four 25.4 mm screws that secure the front of the housing.
Step 5
- Open the housing with the data label facing up.
Open the housing with the data label facing up.
Step 6
- Remove the old bit holder.
Remove the old bit holder.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Paul Sousa
Member since: 10/29/2019
748 Reputation
5 Guides authored
Badges:
9
+6 more badges
Team
UMass Dartmouth, Team S4-G2, Saloman Fall 2019
Member of UMass Dartmouth, Team S4-G2, Saloman Fall 2019
UMASSD-SALOMAN-F19S4G2
3 Members
6 Guides authored
