Difficulty

Difficult

Steps

7

Time Required

                          30 minutes - 1 hour

Sections

2

  • Battery
  • 2 steps
  • Trigger
  • 5 steps

Flags

0

  • BackRyobi P235

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

The trigger assembly is what regulates how much power gets to the motor and what direction the motor spins.

When you reach step 7 and 8, the wires are soldered to the motor so a soldering iron will need to be used to disconnect them from the old trigger assembly and then reattach them to the new one.

What you need

Step 1

              Battery
  • Push in both push tabs on the battery at the same time.
  • They are located below the green housing and are in the middle on both sides of the battery.

Push in both push tabs on the battery at the same time.

They are located below the green housing and are in the middle on both sides of the battery.

1024

Step 2

  • Pull the battery away from the drill housing while holding in both tabs.

Pull the battery away from the drill housing while holding in both tabs.

Step 3

              Trigger
  • Use a Phillips #2 screwdriver to remove the eight 16 mm screws that secure the housing.

Use a Phillips #2 screwdriver to remove the eight 16 mm screws that secure the housing.

Step 4

  • Use a T20 Torx screwdriver to remove the four 25.4 mm screws that secure the front of the housing.

Use a T20 Torx screwdriver to remove the four 25.4 mm screws that secure the front of the housing.

Step 5

  • Open the housing with the data label facing up.

Open the housing with the data label facing up.

Step 6

  • Lift the trigger mechanism and other internal components out of the housing assembly.

Lift the trigger mechanism and other internal components out of the housing assembly.

Step 7

  • Use a soldering iron to remove the black and red wires connecting the trigger assembly to the motor.
  • Use the soldering iron to connect the new trigger assembly to the motor.
  • Make sure the red wire connects to the lead with the red mark on it.

Use a soldering iron to remove the black and red wires connecting the trigger assembly to the motor.

Use the soldering iron to connect the new trigger assembly to the motor.

Make sure the red wire connects to the lead with the red mark on it.

To reassemble your device, follow these instructions in reverse order starting at step 6.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 2 other contributors 


                    Paul Sousa

Member since: 10/29/2019

748 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       UMass Dartmouth, Team S4-G2, Saloman Fall 2019                        

                                                  Member of UMass Dartmouth, Team S4-G2, Saloman Fall 2019 



                    UMASSD-SALOMAN-F19S4G2                     


                                            3 Members                     


                                            6 Guides authored