Ryobi P422 Safety Trigger Spring Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Sections

Battery and Handle
1 step
Safety Trigger Spring
4 steps

Flags

BackRYOBI P422
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery and Handle

To remove the battery press down on the two buttons located on each side of the battery and pull away from the body of the grinder.
To remove the handle hold grinder with one hand and use the other hand to unscrew the handle with a counter-clockwise motion

To remove the battery press down on the two buttons located on each side of the battery and pull away from the body of the grinder.

To remove the handle hold grinder with one hand and use the other hand to unscrew the handle with a counter-clockwise motion

1024

Step 2

              Safety Trigger Spring

Lay grinder flat on its side so the screws are facing up

Lay grinder flat on its side so the screws are facing up

Step 3

Remove the four 1.8 cm screws from the lower and midsection of the body with a T20-20 Torque screwdriver.
Remove the 3.7 cm screws from the upper section of the body, with the same screwdriver

Remove the four 1.8 cm screws from the lower and midsection of the body with a T20-20 Torque screwdriver.

Remove the 3.7 cm screws from the upper section of the body, with the same screwdriver

Step 4

Now that the two halves are unscrewed, remove the top half

Now that the two halves are unscrewed, remove the top half

Step 5

Remove the safety trigger along with the spring.
To remove the spring, pull it gently off the bottom of the trigger.
When putting a new spring in make sure it slides into the grove on the bottom of the trigger.

Remove the safety trigger along with the spring.

To remove the spring, pull it gently off the bottom of the trigger.

When putting a new spring in make sure it slides into the grove on the bottom of the trigger.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Thomas Napert

Member since: 03/16/2015

243 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UMass Dartmouth, Team 3-6, Duarte Spring 2015                        

                                                  Member of UMass Dartmouth, Team 3-6, Duarte Spring 2015 



                    UMASSD-DUARTE-S15S3G6                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team