Difficulty

Moderate

Steps

10

Time Required

Suggest a time??

Sections

2

  • Saw Bar Assembly
  • 7 steps
  • Assembly Bar Bearing
  • 3 steps

Flags

4

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Missed a Step

Oops! This guide is currently missing some important steps.

Better Introduction

Improve this guide by completing or revising its introduction.

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

  • BackRyobi RJ1861V

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Saw Bar Assembly
  • Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

1024

Step 2

  • Remove the rubber sleeve.
  • You may have to use some force as it has a tight fit.

Remove the rubber sleeve.

You may have to use some force as it has a tight fit.

Step 3

  • Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

Step 4

  • Use a Torx T5 screwdriver to remove the four screws on the top.
  • There are two screws on each side of the device.

Use a Torx T5 screwdriver to remove the four screws on the top.

There are two screws on each side of the device.

Step 5

  • Remove the backside panel.

Remove the backside panel.

Step 6

  • Unscrew the four T5 Torx screws that are holding the assembly bar in place.

Unscrew the four T5 Torx screws that are holding the assembly bar in place.

Step 7

  • Lift the assembly bar up and out of the chassis.

Lift the assembly bar up and out of the chassis.

Step 8

              Assembly Bar Bearing
  • Begin with the top of the device facing up.

Begin with the top of the device facing up.

Step 9

  • Insert needle nose pliers to remove the retaining pin at the top of the bearing.

Insert needle nose pliers to remove the retaining pin at the top of the bearing.

Step 10

  • Once the retaining pin has been removed, pull off the damaged bearing and insert a new one.

Once the retaining pin has been removed, pull off the damaged bearing and insert a new one.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 2 other contributors 


                    Morgan Doyle

Member since: 04/08/2019

316 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Eastern Washington University, Team S1-G1, Rowley Spring 2019                        

                                                  Member of Eastern Washington University, Team S1-G1, Rowley Spring 2019 



                    EWU-ROWLEY-S19S1G1                     


                                            3 Members                     


                                            3 Guides authored