Difficulty
Moderate
Steps
4
Time Required
5 - 8 minutes
Sections
2
- Trigger Assembly
- 2 steps
- Motor Housing
- 2 steps
Flags
Missed a Step
Oops! This guide is currently missing some important steps.
Better Introduction
Improve this guide by completing or revising its introduction.
BackRyobi RJ1861V
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Trigger Assembly
- Use a Torx T20 screwdriver to remove the nine 16.5 mm screws around the trigger assembly.
Use a Torx T20 screwdriver to remove the nine 16.5 mm screws around the trigger assembly.
1024
Step 2
- Use a Torx T20 screwdriver to remove the two 16.5 mm screws near the trigger.
Use a Torx T20 screwdriver to remove the two 16.5 mm screws near the trigger.
Step 3
Motor Housing
- Use a Torx T20 bit or screwdriver to remove the six 19 mm screws securing the gear case cover.
Use a Torx T20 bit or screwdriver to remove the six 19 mm screws securing the gear case cover.
Step 4
- Use a Phillips #2 bit or screwdriver to remove the four 37 mm screws from the top and the bottom of the gear case.
- Once these 4 screws are removed, you have access to the motor assembly.
Use a Phillips #2 bit or screwdriver to remove the four 37 mm screws from the top and the bottom of the gear case.
Once these 4 screws are removed, you have access to the motor assembly.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Nicholas Bernissant Boyd
Member since: 02/11/2022
85 Reputation
1 Guide authored
Badges:
3
Team
The Citadel Military College of South Carolina, Team 1-3, Eggleston Spring 2022
Member of The Citadel Military College of South Carolina, Team 1-3, Eggleston Spring 2022
CMCSC-EGGLESTON-S22S1G3
3 Members
2 Guides authored