Ryobi Rj1861V Saw Bar Assembly Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          10 - 20 minutes            

Sections

1

• Saw Bar Assembly
• 7 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

• BackRyobi RJ1861V

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Saw Bar Assembly               

• Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

1024

Step 2

• Remove the rubber sleeve.
• You may have to use some force as it has a tight fit.

Remove the rubber sleeve.

You may have to use some force as it has a tight fit.

Step 3

• Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

Step 4

• Use a Torx T5 screwdriver to remove the four screws on the top.
• There are two screws on each side of the device.

Use a Torx T5 screwdriver to remove the four screws on the top.

There are two screws on each side of the device.

Step 5

• Remove the backside panel.

Remove the backside panel.

Step 6

• Unscrew the four T5 Torx screws that are holding the assembly bar in place.

Unscrew the four T5 Torx screws that are holding the assembly bar in place.

Step 7

• Lift the assembly bar up and out of the chassis.

Lift the assembly bar up and out of the chassis.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Ryan Quinlivan                     

Member since: 04/08/2019

306 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge                           

Team

                       Eastern Washington University, Team S25-G2, Crane Spring 2020                        

                                                  Member of Eastern Washington University, Team S25-G2, Crane Spring 2020 



                    EWU-CRANE-S20S25G2                     


                                            4 Members                     


                                            3 Guides authored