Difficulty

Moderate

Steps

4

Time Required

                          5 - 15 minutes

Sections

1

  • Bearing Cap Assembly
  • 4 steps

Flags

2

Missed a Step

Oops! This guide is currently missing some important steps.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackRyobi RS290G

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bearing Cap Assembly
  • Using a TR20 Torx security screwdriver, remove the four 6mm screws.
  • Make sure to hold the backing pad firmly to prevent spinning.

Using a TR20 Torx security screwdriver, remove the four 6mm screws.

Make sure to hold the backing pad firmly to prevent spinning.

1024

Step 2

  • After removing the backing pad, carefully pull on the rubber brake to remove it from the housing assembly.

After removing the backing pad, carefully pull on the rubber brake to remove it from the housing assembly.

Step 3

  • Using a TR 20 Torx security screwdriver, remove the single 3mm screw in the center of the bearing cap assembly.
  • Make sure to use pliers or another tool to prevent the fan from spinning, and use a torque wrench or torque screwdriver as the screw is secured with Loctite (a compound to prevent it from loosening).

Using a TR 20 Torx security screwdriver, remove the single 3mm screw in the center of the bearing cap assembly.

Make sure to use pliers or another tool to prevent the fan from spinning, and use a torque wrench or torque screwdriver as the screw is secured with Loctite (a compound to prevent it from loosening).

Step 4

  • Remove the bearing cap.
  • You may keep the spring washer and washer for reuse if they are not worn/damaged.

Remove the bearing cap.

You may keep the spring washer and washer for reuse if they are not worn/damaged.

To reassemble your device, follow these instructions in reverse order. Make sure to tighten down properly to avoid loose or traction pad issues.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Daniel

Member since: 09/17/2019

639 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Embry-Riddle Aeronautical University, Team S22-G5, Branham Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S22-G5, Branham Fall 2019 



                    ERAU-BRANHAM-F19S22G5                     


                                            4 Members                     


                                            5 Guides authored