Difficulty

Difficult

Steps

12

Time Required

                          10 - 30 minutes

Sections

3

  • Top Cap
  • 3 steps
  • Switch Trigger
  • 1 step
  • Power Cord
  • 8 steps

Flags

2

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackRyobi RS290G

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Top Cap
  • Remove two 20mm and one 16mm Phillips #2 screws from the housing assembly and exhaust port.

Remove two 20mm and one 16mm Phillips #2 screws from the housing assembly and exhaust port.

1024

Step 2

  • Remove the three 16mm Phillips #2 screws from the top cap/upper grip.

Remove the three 16mm Phillips #2 screws from the top cap/upper grip.

Step 3

  • Remove the top cap.

Remove the top cap.

Step 4

              Switch Trigger
  • Remove the switch trigger.

Remove the switch trigger.

Step 5

              Power Cord
  • Remove the two 16mm Phillips #2 screws from the inner housing assembly.

Remove the two 16mm Phillips #2 screws from the inner housing assembly.

Step 6

  • Remove the two 14mm Phillips #2 screws from the cord clamp.

Remove the two 14mm Phillips #2 screws from the cord clamp.

Step 7

  • Slide the power switch out of the housing assembly, carefully gripping the switch and pulling it upward.

Slide the power switch out of the housing assembly, carefully gripping the switch and pulling it upward.

Step 8

  • Remove the black lead from the power switch using a spudger.

Remove the black lead from the power switch using a spudger.

Step 9

  • Carefully slide the housing assembly apart, avoiding damage or pulling on wires.

Carefully slide the housing assembly apart, avoiding damage or pulling on wires.

Step 10

  • Slide out the brush assembly with the white lead from the inner housing assembly.

Slide out the brush assembly with the white lead from the inner housing assembly.

Step 11

  • Remove the white lead from the brush assembly.

Remove the white lead from the brush assembly.

Step 12

  • Slide the bend relief off of the old power cord to reuse on the new power cord if there is no damage.

Slide the bend relief off of the old power cord to reuse on the new power cord if there is no damage.

To reassemble your device, follow these instructions in reverse order. Make sure to perform an operational check after reassembling.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Daniel

Member since: 09/17/2019

639 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Embry-Riddle Aeronautical University, Team S22-G5, Branham Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S22-G5, Branham Fall 2019 



                    ERAU-BRANHAM-F19S22G5                     


                                            4 Members                     


                                            5 Guides authored