Difficulty

Moderate

Steps

7

Time Required

                          4 - 5 minutes

Sections

2

  • Back Panel
  • 2 steps
  • Motherboard
  • 5 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackSamsung S27E510C

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Use the #1 Phillips head screw driver to remove each 13.75mm length screw from the rear panel.
  • The screw alone with the ports is a different size than the rest, its length is 12mm.

Use the #1 Phillips head screw driver to remove each 13.75mm length screw from the rear panel.

The screw alone with the ports is a different size than the rest, its length is 12mm.

1024

Step 2

  • Insert the heavy duty spudger in between the monitors back panel and its frame.
  • Use the heavy duty spudger to pry open the back panel.
  • Over aggressive prying could break the tabs holding the back panel in place.

Insert the heavy duty spudger in between the monitors back panel and its frame.

Use the heavy duty spudger to pry open the back panel.

Over aggressive prying could break the tabs holding the back panel in place.

Step 3

              Motherboard
  • Remove the navigation button connector by pulling while holding down its thumb tab.

Remove the navigation button connector by pulling while holding down its thumb tab.

Step 4

  • Remove the screen connector by gripping its sides and gently pulling while wiggling back and forth.

Remove the screen connector by gripping its sides and gently pulling while wiggling back and forth.

Step 5

  • For the ribbon cable, Lift the tab from the side facing the inside of the mother board with your fingernail or a spudger.
  • Remove the cable by pulling while lifting slightly.
  • If the cable does not come out easily, than the secure tab may not be fully opened.

For the ribbon cable, Lift the tab from the side facing the inside of the mother board with your fingernail or a spudger.

Remove the cable by pulling while lifting slightly.

If the cable does not come out easily, than the secure tab may not be fully opened.

Step 6

  • Remove each of the 5mm length screws attaching the motherboard to the body of the monitor using a #1 Phillips head screwdriver.

Remove each of the 5mm length screws attaching the motherboard to the body of the monitor using a #1 Phillips head screwdriver.

Step 7

  • Using both hands, lift the board off of the monitor body by the motherboards base.

Using both hands, lift the board off of the monitor body by the motherboards base.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    giggythore

Member since: 10/14/2017

354 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Cal Poly, Team S9-G1, Banghart Fall 2017                        

                                                  Member of Cal Poly, Team S9-G1, Banghart Fall 2017 



                    CPSU-BANGHART-F17S9G1                     


                                            6 Members                     


                                            7 Guides authored