Samsung 27E510C Nav Button Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          4 - 5 minutes

Sections

Back Panel
2 steps
Rear navigation button
5 steps

Flags

BackSamsung S27E510C
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

Use the #1 Phillips head screw driver to remove each 13.75mm length screw from the rear panel.
The screw alone with the ports is a different size than the rest, its length is 12mm.

Use the #1 Phillips head screw driver to remove each 13.75mm length screw from the rear panel.

The screw alone with the ports is a different size than the rest, its length is 12mm.

1024

Step 2

Insert the heavy duty spudger in between the monitors back panel and its frame.
Use the heavy duty spudger to pry open the back panel.
Over aggressive prying could break the tabs holding the back panel in place.

Insert the heavy duty spudger in between the monitors back panel and its frame.

Use the heavy duty spudger to pry open the back panel.

Over aggressive prying could break the tabs holding the back panel in place.

Step 3

              Rear navigation button

Carefully remove the tape holding down the connector wire.
You will need to re-attach the tape upon reassembly.

Carefully remove the tape holding down the connector wire.

You will need to re-attach the tape upon reassembly.

Step 4

Disconnect the navigation button from the motherboard by holding down the thumb tab and pulling its connector out.

Disconnect the navigation button from the motherboard by holding down the thumb tab and pulling its connector out.

Step 5

Remove the navigation buttons connector wire from the monitors body tab.

Remove the navigation buttons connector wire from the monitors body tab.

Step 6

With one thumb, hold down the tab on the bottom of the navigation buttons base.
While holding the tab down, lift the base of the navigation button with your other hand.

With one thumb, hold down the tab on the bottom of the navigation buttons base.

While holding the tab down, lift the base of the navigation button with your other hand.

Step 7

Remove the connector wire from the defective navigation button by first gripping its connectors thumb tab.
While gripping the thumb tab, pull the connector from the base of the navigation button.
You can save the connector wire since it may not be defective.

Remove the connector wire from the defective navigation button by first gripping its connectors thumb tab.

While gripping the thumb tab, pull the connector from the base of the navigation button.

You can save the connector wire since it may not be defective.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    giggythore

Member since: 10/14/2017

354 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Cal Poly, Team S9-G1, Banghart Fall 2017                        

                                                  Member of Cal Poly, Team S9-G1, Banghart Fall 2017 



                    CPSU-BANGHART-F17S9G1                     


                                            6 Members                     


                                            7 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team