Difficulty

Moderate

Steps

6

Time Required

                          10 - 20 minutes

Sections

1

  • Battery
  • 6 steps

Flags

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

  • BackSamsung ATIV Book 4

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Place the computer upside down.
  • Remove 2 rubber pads, by prying up on them.
  • There may be adhesive holding them down. If this is the case, the plastic opening tool may be needed to remove them.
  • Remove the seven 6.5mm screws on exterior of computer.

Place the computer upside down.

Remove 2 rubber pads, by prying up on them.

There may be adhesive holding them down. If this is the case, the plastic opening tool may be needed to remove them.

Remove the seven 6.5mm screws on exterior of computer.

1024

Step 2

  • Remove the panel by sliding it down and lifting it away from the computer.
  • Remove the four 4.4mm screws that are underneath the panel.
  • Remove the two 6.5mm screws that were underneath the rubber pads.

Remove the panel by sliding it down and lifting it away from the computer.

Remove the four 4.4mm screws that are underneath the panel.

Remove the two 6.5mm screws that were underneath the rubber pads.

Step 3

  • Using the plastic opening tool, pry plastic panel away from computer.
  • Start prying at one point and work your way around the entire computer until panel is free come computer.
  • Remove the panel from computer, once all tabs are broken free.

Using the plastic opening tool, pry plastic panel away from computer.

Start prying at one point and work your way around the entire computer until panel is free come computer.

Remove the panel from computer, once all tabs are broken free.

Step 4

  • Remove the four 3.5mm screws holding the battery.
  • Peel back the tape securing the wires to the battery.
  • Lift and remove the battery from its location.
  • Don’t pull/tear the wires connected to battery harness.

Remove the four 3.5mm screws holding the battery.

Peel back the tape securing the wires to the battery.

Lift and remove the battery from its location.

Don’t pull/tear the wires connected to battery harness.

Step 5

  • Disconnect the battery harness from computer.
  • Completely remove the battery and replace it.

Disconnect the battery harness from computer.

Completely remove the battery and replace it.

Step 6

  • Plug battery harness back in.
  • Assure the wires are pointed up (towards you) then plugging back in, as shown.

Plug battery harness back in.

Assure the wires are pointed up (towards you) then plugging back in, as shown.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 2 other contributors 


                    Chad

Member since: 03/17/2015

437 Reputation

                                      2 Guides authored                  



                       Badges:
                       16







                                                        +13 more badges

Team

                       Michigan Tech, Team 1-7, Lauer Spring 2015                        

                                                  Member of Michigan Tech, Team 1-7, Lauer Spring 2015 



                    MTU-LAUER-S15S1G7                     


                                            2 Members                     


                                            5 Guides authored