Samsung Ativ Book 4 Mouse Pad Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 - 20 minutes

Sections

Mouse Pad
4 steps

Flags

BackSamsung ATIV Book 4
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Mouse Pad

Place the computer upside down.
Remove the two rubber pads, by prying up on them.
There may be adhesive holding them down.
Remove the seven 6.5mm screws on exterior of computer.
Remove panel by sliding it down and lifting it away from the computer.

Place the computer upside down.

Remove the two rubber pads, by prying up on them.

There may be adhesive holding them down.

Remove the seven 6.5mm screws on exterior of computer.

Remove panel by sliding it down and lifting it away from the computer.

1024

Step 2

Remove the four 4.4mm screws that are underneath the panel.
Remove the two 6.5mm screws that were underneath the rubber pads.

Remove the four 4.4mm screws that are underneath the panel.

Remove the two 6.5mm screws that were underneath the rubber pads.

Step 3

Using plastic opening tool, pry plastic panel away from computer.
Start prying at one point and work your way around the entire computer until panel is free come computer.
Remove the panel from computer once all tabs are broke free.

Using plastic opening tool, pry plastic panel away from computer.

Start prying at one point and work your way around the entire computer until panel is free come computer.

Remove the panel from computer once all tabs are broke free.

Step 4

Pull this tab outwards, as shown, to release the wire harness.
With the tab now pulled out, pull lightly on the blue tape, to remove the harness.
Pull on the blue tape to remove wire harness.
This harness may require a little more force to remove, but will slide right out.
Remove the two 3.5mm screws and remove the defective hardware.
This step may be easier if the battery is taken out. Follow the battery replacement guide to do so.

Pull this tab outwards, as shown, to release the wire harness.

With the tab now pulled out, pull lightly on the blue tape, to remove the harness.

Pull on the blue tape to remove wire harness.

This harness may require a little more force to remove, but will slide right out.

Remove the two 3.5mm screws and remove the defective hardware.

This step may be easier if the battery is taken out. Follow the battery replacement guide to do so.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Daniel

Member since: 03/19/2015

342 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Michigan Tech, Team 1-7, Lauer Spring 2015                        

                                                  Member of Michigan Tech, Team 1-7, Lauer Spring 2015 



                    MTU-LAUER-S15S1G7                     


                                            2 Members                     


                                            5 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team