Samsung Bd F5900 Main Logic Board Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Top Cover
2 steps
Power Supply
3 steps
Main Logic Board
3 steps

Flags

BackSamsung BD-F5900
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Top Cover

Using a #1 Phillips head screwdriver, remove the three 10mm screws on the back panel.
Tilt the back of the top cover forward to remove from chassis.

Using a #1 Phillips head screwdriver, remove the three 10mm screws on the back panel.

Tilt the back of the top cover forward to remove from chassis.

1024

Step 2

Gently pull up on the ribbon cable by the blue tab to remove it from the power supply board.

Gently pull up on the ribbon cable by the blue tab to remove it from the power supply board.

Step 3

              Power Supply

Using a #1 Phillips head screwdriver, remove the two 7.5mm screws on top of the plastic cover and remove the cover.

Using a #1 Phillips head screwdriver, remove the two 7.5mm screws on top of the plastic cover and remove the cover.

Step 4

Press down on the plastic retaining clip and pull backwards to remove the AC power connector from the power supply board.

Press down on the plastic retaining clip and pull backwards to remove the AC power connector from the power supply board.

Step 5

Using the plastic spudger tool, gently pry on either side of main power connector (CON801) to disconnect from main logic board.
Pry a little bit on each side of board until the board lifts away.
Tilt the board forward and lift up to remove from the chassis.

Using the plastic spudger tool, gently pry on either side of main power connector (CON801) to disconnect from main logic board.

Pry a little bit on each side of board until the board lifts away.

Tilt the board forward and lift up to remove from the chassis.

Step 6

              Main Logic Board

Remove the two ribbon cables from the Main Logic Board assembly by gently pulling up on the blue tab.
Be careful not to damage the ribbon cable by using too much force.

Remove the two ribbon cables from the Main Logic Board assembly by gently pulling up on the blue tab.

Be careful not to damage the ribbon cable by using too much force.

Step 7

Disconnect the WiFi board cable connector

Disconnect the WiFi board cable connector

Step 8

Using a #1 Phillips head screwdriver, remove the three 7.5 mm screws from the board
Also remove the 10 mm screw from the rear panel.
Remove the Main Logic Board

Using a #1 Phillips head screwdriver, remove the three 7.5 mm screws from the board

Also remove the 10 mm screw from the rear panel.

Remove the Main Logic Board

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Louis McKean

Member since: 10/18/2017

501 Reputation

                                      5 Guides authored                  



                       Badges:
                       3

Team

                       USF Tampa, Team S1-G21, Cagle Fall 2017                        

                                                  Member of USF Tampa, Team S1-G21, Cagle Fall 2017 



                    USFT-CAGLE-F17S1G21                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team