Difficulty
Easy
Steps
4
Time Required
10 minutes
Sections
1
- Disc Tray
- 4 steps
Flags
0
BackSamsung BD-F7500
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Disc Tray
- Use a Phillips head #J1 screwdriver to remove all three (3) 10 mm screws.
Use a Phillips head #J1 screwdriver to remove all three (3) 10 mm screws.
1024
Step 2
- To remove each ribbon cable, firmly grip the hard plastic tab attached to the base and pull upwards.
- Be careful not to tear the ribbon cables.
To remove each ribbon cable, firmly grip the hard plastic tab attached to the base and pull upwards.
Be careful not to tear the ribbon cables.
Step 3
- Using a screwdriver with a #J1 bit, remove the two (2) 7 mm screws.
Using a screwdriver with a #J1 bit, remove the two (2) 7 mm screws.
Step 4
- Locate the two black tabs on each side of the disc tray. The second tab is located in the same location on opposite side of marked tab.
- While pinching both tabs, slightly push the disc tray towards the front of the device, and lift the disc tray out.
Locate the two black tabs on each side of the disc tray. The second tab is located in the same location on opposite side of marked tab.
While pinching both tabs, slightly push the disc tray towards the front of the device, and lift the disc tray out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
James McMicheal
Member since: 09/28/2017
511 Reputation
5 Guides authored
Badges:
6
+3 more badges
Team
Eastern Washington University, Team S2-G6, Crane Fall 2017
Member of Eastern Washington University, Team S2-G6, Crane Fall 2017
EWU-CRANE-F17S2G6
4 Members
5 Guides authored