Samsung Bd Jm57C Power Cord Replacement Repair Guide

Difficulty

Easy

Steps

8

Time Required

                          5 - 7 minutes            

Sections

4

• Top Cover
• 1 step
• Disc Drive
• 2 steps
• WiFi Card
• 1 step
• Power Cord
• 4 steps

Flags

0

• BackSamsung BD-JM57C

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Make sure the device is not plugged in before working on it.

What you need

Step 1

              Top Cover               

• Use the Phillips #00 Screwdriver to remove the single 9.6mm screw holding the top cover in place.
• Remove the cover by sliding it up and then out.

Use the Phillips #00 Screwdriver to remove the single 9.6mm screw holding the top cover in place.

Remove the cover by sliding it up and then out.

1024

Step 2

              Disc Drive               

• Disconnect the two ribbons that connect the disc drive to the motherboard.

Disconnect the two ribbons that connect the disc drive to the motherboard.

Step 3

• Push in on the two metal tabs on the side of the disc drive.
• Push forward to slide the disc drive out of the casing.

Push in on the two metal tabs on the side of the disc drive.

Push forward to slide the disc drive out of the casing.

Step 4

              WiFi Card               

• Pull clip to remove the WiFi card ribbon connected to the circuit board.
• Push the black plastic tab out and slide the WiFi card out from the cage.

Pull clip to remove the WiFi card ribbon connected to the circuit board.

Push the black plastic tab out and slide the WiFi card out from the cage.

Step 5

              Power Cord               

• Use the Phillips #00 Screwdriver to remove the two 6.4 mm screws holding the cage in place.
• Lift the cage up to remove it.

Use the Phillips #00 Screwdriver to remove the two 6.4 mm screws holding the cage in place.

Lift the cage up to remove it.

Step 6

• Push in the small white lever and pull it towards you to release the cord.

Push in the small white lever and pull it towards you to release the cord.

Step 7

• Move the power cord out from under the metal tab on the side of the case.

Move the power cord out from under the metal tab on the side of the case.

Step 8

• Remove the rubber spacer on the edge of the case holding the cord in place.
• Remove the power cord from the device.

Remove the rubber spacer on the edge of the case holding the cord in place.

Remove the power cord from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Abby Hudson                     

Member since: 01/14/2020

637 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       Embry-Riddle Aeronautical University, Team S1-G5, Cromer Twal Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S1-G5, Cromer Twal Spring 2020 



                    ERAU-CROMER TWAL-S20S1G5                     


                                            4 Members                     


                                            5 Guides authored