Difficulty
Easy
Steps
4
Time Required
5 - 10 minutes
Sections
3
- Top Cover
- 1 step
- Disc Drive
- 2 steps
- WiFi Card
- 1 step
Flags
0
BackSamsung BD-JM57C
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Make sure the device is not plugged in before working on it.
What you need
Step 1
Top Cover
- Use the Phillips #00 Screwdriver to remove the single 9.6mm screw holding the top cover in place.
- Remove the cover by sliding it up and then out.
Use the Phillips #00 Screwdriver to remove the single 9.6mm screw holding the top cover in place.
Remove the cover by sliding it up and then out.
1024
Step 2
Disc Drive
- Disconnect the two ribbons that connect the disc drive to the motherboard.
Disconnect the two ribbons that connect the disc drive to the motherboard.
Step 3
- Push in on the two metal tabs on the side of the disc drive.
- Push forward to slide the disc drive out of the casing.
Push in on the two metal tabs on the side of the disc drive.
Push forward to slide the disc drive out of the casing.
Step 4
WiFi Card
- Pull clip to remove the WiFi card ribbon connected to the circuit board.
- Push the black plastic tab out and slide the WiFi card out from the cage.
Pull clip to remove the WiFi card ribbon connected to the circuit board.
Push the black plastic tab out and slide the WiFi card out from the cage.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Abby Hudson
Member since: 01/14/2020
637 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
Embry-Riddle Aeronautical University, Team S1-G5, Cromer Twal Spring 2020
Member of Embry-Riddle Aeronautical University, Team S1-G5, Cromer Twal Spring 2020
ERAU-CROMER TWAL-S20S1G5
4 Members
5 Guides authored