Difficulty
Moderate
Steps
7
Time Required
15 - 30 minutes
Sections
1
- Speaker Module
- 7 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackSamsung Brightside
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Speaker Module
- Here is the Samsung SCH-U380 Brightside
- Turn it over to gain access to the battery.
- Remove the backcover by simply pulling it off the phone from the top down
Here is the Samsung SCH-U380 Brightside
Turn it over to gain access to the battery.
Remove the backcover by simply pulling it off the phone from the top down
1024
Step 2
- Remove the battery
- Remove the six Phillips screws from the back frame
- All six screws are identical M1.5X3
Remove the battery
Remove the six Phillips screws from the back frame
All six screws are identical M1.5X3
Step 3
- Use a plastic opening tool or similar tool to separate the top from the bottom frame. Applying slight pressure in a downwards direction will disengage the plastic clips
- Continue to slide the tool along the slot until you feel the plastic locks disengage
- Once all locks have released, the bottom frame can simply be removed.
Use a plastic opening tool or similar tool to separate the top from the bottom frame. Applying slight pressure in a downwards direction will disengage the plastic clips
Continue to slide the tool along the slot until you feel the plastic locks disengage
Once all locks have released, the bottom frame can simply be removed.
Step 4
- Remove the two Phillips screws from the EMI shield.
- Both screws are identical M1.5X2
- Remove the EMI shield
Remove the two Phillips screws from the EMI shield.
Both screws are identical M1.5X2
Remove the EMI shield
Step 5
- Detach the LCD connector.
- Remove the logic board
- This is the speaker module. In the center is the camera, but it is not part of the module.
Detach the LCD connector.
Remove the logic board
This is the speaker module. In the center is the camera, but it is not part of the module.
Step 6
- turn the logic board over. The speaker module is held in place
- by one Phillips screw
- and two clips
- Remove the Phillips screw.
- It is a M1X2 Phillips screw
- Next disengage one of the clips by simply applying some sideways pressure with your fingernail. This will loosen the module.
turn the logic board over. The speaker module is held in place
by one Phillips screw
and two clips
Remove the Phillips screw.
It is a M1X2 Phillips screw
Next disengage one of the clips by simply applying some sideways pressure with your fingernail. This will loosen the module.
Step 7
- Turn the logic board around. With the speaker module loose, simply lift it off the board.
- Speaker module removed.
- Camera
- and audio jack
- are not part of this module and will remain on the board.
Turn the logic board around. With the speaker module loose, simply lift it off the board.
Speaker module removed.
Camera
and audio jack
are not part of this module and will remain on the board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
oldturkey03
Member since: 09/29/2010
722,317 Reputation
109 Guides authored
Badges:
53
+50 more badges
Team
Global Fixers
Member of Global Fixers
Community
22 Members
240 Guides authored