Difficulty

Moderate

Steps

9

Time Required

                          15 - 20 minutes

Sections

2

  • Disk Tray Replacement
  • 5 steps
  • Disk Drive Motor
  • 4 steps

Flags

0

  • BackSamsung DVD-HD850

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Locate and Remove The Disk Tray
  • NOTE remember to never connect to power when working on electrical components
  • Find and locate the disk tray it is located top right hand side of the component when the back of the device ( dvd player ) is facing you.

NOTE remember to never connect to power when working on electrical components

Find and locate the disk tray it is located top right hand side of the component when the back of the device ( dvd player ) is facing you.

1024

Step 2

              Removing The Data Strips
  • Locate and gently remove the data strips on the tray. There are three in total, two on the left hand side and one on the right.

Locate and gently remove the data strips on the tray. There are three in total, two on the left hand side and one on the right.

Step 3

              Removing The Screws
  • As noted by the red circles, locate and remove the screws one at a time

As noted by the red circles, locate and remove the screws one at a time

Step 4

              Disk Tray Removal
  • After removing the clips slowly incline the disk drive towards you and unclip it from the two (2) brackets located on the top
  • Be careful not to push too much pressure on the brackets since they tend to break easily

After removing the clips slowly incline the disk drive towards you and unclip it from the two (2) brackets located on the top

Be careful not to push too much pressure on the brackets since they tend to break easily

Step 5

              Success!
  • Congrats! You have sucessfully have taken out the disk drive

Congrats! You have sucessfully have taken out the disk drive

Step 6

              Disassemble the motor from the disk tray
  • NOTE remember to never connect to power when working on electrical components
  • Remove screws as noted by the picture

Remove screws as noted by the picture

Step 7

              Removing Data Strips
  • Slowly remove the circuit board/cables/strips from under the black bar. ( under and over)
  • Be careful not to pull it hard, due to these cable are fragile and can break easliy

Slowly remove the circuit board/cables/strips from under the black bar. ( under and over)

Be careful not to pull it hard, due to these cable are fragile and can break easliy

Step 8

              Replacing Motor
  • Replace the motor in question ( usually both are needed to be replaced)

Replace the motor in question ( usually both are needed to be replaced)

Step 9

              Reassembly
  • To reassembly do these steps in reverse order

To reassembly do these steps in reverse order

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Carlos

Member since: 10/16/2014

354 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UMass Dartmouth, Team 1-6, Duarte Fall 2014                        

                                                  Member of UMass Dartmouth, Team 1-6, Duarte Fall 2014 



                    UMASSD-DUARTE-F14S1G6                     


                                            3 Members                     


                                            7 Guides authored