Difficulty

Easy

Steps

5

Time Required

                          15 - 30 minutes

Sections

2

  • Cover
  • 3 steps
  • Power Cord
  • 2 steps

Flags

1

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

  • BackSamsung DVD-HD850

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Cover
  • with the front of the device facing you, turn the device 180 degrees so the back panel of the device is facing you

with the front of the device facing you, turn the device 180 degrees so the back panel of the device is facing you

1024

Step 2

              Locate and remove screws
  • locate the three (3) screws on the back panel of the device that are implanted in the device
  • to remove the screws, use the tool(s) listed above (right underneath the introduction) and twist the screws counter-clockwise to remove them from the device

locate the three (3) screws on the back panel of the device that are implanted in the device

to remove the screws, use the tool(s) listed above (right underneath the introduction) and twist the screws counter-clockwise to remove them from the device

Step 3

              Remove Cover
  • to remove the cover of the device, pull the cover towards the back of the device until it is completely removed so you can see the insides of the device

to remove the cover of the device, pull the cover towards the back of the device until it is completely removed so you can see the insides of the device

Step 4

              Replacing the power cord
  • Unclip the old power cord from the dual pin connector.
  • Once the old power cord has been unclipped take the new power cord and simply clip it in where the old one was.

Unclip the old power cord from the dual pin connector.

Once the old power cord has been unclipped take the new power cord and simply clip it in where the old one was.

Step 5

              Adjust the wire
  • Adjust the rubber block on the power cord so that it fits in the slot on the back of the DVD player.
  • This makes it so that the cover panel will be able to slide back on.

Adjust the rubber block on the power cord so that it fits in the slot on the back of the DVD player.

This makes it so that the cover panel will be able to slide back on.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Robert Moss

Member since: 10/22/2014

201 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       UMass Dartmouth, Team 1-6, Duarte Fall 2014                        

                                                  Member of UMass Dartmouth, Team 1-6, Duarte Fall 2014 



                    UMASSD-DUARTE-F14S1G6                     


                                            3 Members                     


                                            7 Guides authored